Coverage Explained

Commercial Auto Insurance for a Plumbing Business With Multiple Vehicles

A plumbing business with several vehicles normally insures them together on one commercial auto policy that lists each vehicle and each driver. The policy is built around those two lists, plus a decision about vehicles the company does not own. Getting the lists right at the start, and keeping them right, is most of the work.

How does one policy hold several plumbing vehicles?

One commercial auto policy is a single contract with a schedule of vehicles attached to it, so adding a van does not mean starting a new policy from scratch. The company is named as the insured, and each truck, van or trailer you own is described on the schedule beneath that one named insured.

Triple-I makes the ownership point plainly: if the business owns the vehicle, the business should appear on the policy as the principal insured. For a plumbing company that matters because a van titled to the owner personally, or to a spouse, can sit outside the structure everyone assumes is covering it.

The commercial auto coverage page describes the lines the policy typically contains: liability for harm the vehicles do to other people and their property, physical damage for the vehicles themselves, and hired and non-owned auto. The setup questions below decide how those lines attach to your particular fleet.

One commercial auto policy, one named insured
Schedule of vehicles
Each owned van, truck and trailer, with its use
Schedule of drivers
Regular drivers and occasional ones, disclosed
Hired and non-owned
Rented vans and employees’ own vehicles
One wide band stands for the single policy and its single named insured. Beneath it sit three parts that the policy holds together: the list of vehicles you own, the list of people who drive them, and the provisions for vehicles you do not own. The shared policy is highlighted because the three parts only work when they are kept current together. No figures are shown.

What belongs on the vehicle schedule?

The schedule should describe every vehicle you own and use in the business, and the description should match how each one actually works. Expect to give the year, make and model, the vehicle identification number, who holds the title, and whether it is owned or leased. Those are the plain identifiers.

What an underwriter cares about beyond that is how the vehicle is used. Triple-I advises that a good agent will ask how vehicles are used in the business. For a plumbing contractor that usually means describing the pattern honestly: residential service calls within a metro area, remodel work that sends a truck to the same address for weeks, commercial jobs that take a crew farther afield, or a mix of all three.

Include the vehicles that are easy to forget: a trailer that hauls a jetter, the pickup the owner drives to bid jobs, a spare van kept for a seasonal rush. If it is used for the business, put it on the list or ask your agent why it should not be.

Tools and parts inside the van are a different matter. They are not part of the auto schedule in the way the vehicle is. The equipment discussion for service trucks and the contractors equipment coverage page explain where that property is handled.

What does an underwriter ask about the drivers?

An underwriter wants to know who drives, because the driver is a large part of what is being insured. Triple-I says a good agent will ask who drives the vehicles, and that is the question to prepare for first. Expect to supply names and license information for the people who will drive company vehicles regularly, and to be asked about their experience behind the wheel.

Say which vehicles are assigned to one technician and which are shared by the crew, since that shapes how the driver list is written.

Also describe the occasional drivers. Office staff who run a parts errand, a new apprentice who rides along and may drive on a slow day, and a part-time helper are all people to mention rather than leave out. Policies and carriers differ on how they treat someone who is not on the list, so ask directly what happens if an unlisted person has an accident in a company van. It is better to hear the answer from your agent now than from a claims adjuster later.

Who is allowed to drive, and how you check licenses, are also claim-prevention habits; see how plumbing contractors reduce claims.

How do you add or remove a vehicle in the middle of the term?

You tell your agent when the fleet changes, and the vehicle is added to or removed from the schedule under the policy’s own terms. Plumbing fleets are not static. A growing company buys a van mid-season, sells an older truck, or replaces a leased one.

When you buy or lease a vehicle, contact the agent before it is driven for the business, not afterward. Ask whether the vehicle is covered automatically for a period, how that works, and what you must report and by when. Policies handle newly acquired vehicles in different ways, and this is exactly the sort of wording to have explained before you need it, rather than assumed.

When you sell or retire a vehicle, report that too. The policy should describe what you own today. Also tell the agent when the use of a vehicle changes: a van that ran light residential calls and now hauls heavier loads to commercial jobs is no longer the vehicle that was described at the start.

What if the fleet mixes pickups, cargo vans and heavier trucks?

A mixed fleet can still go on one policy, but each vehicle type should be described for what it is. A plumbing company often runs light pickups for estimators, cargo vans for service techs, and larger trucks or trailers for excavation, jetting or hauling pipe. The National Association of Insurance Commissioners lists provisions for operation of heavy-duty vehicles and for transported goods or people among the features commercial auto policies typically have, which is a reason to name the heavier equipment rather than fold it into a general description.

Say so if any vehicle regularly carries more than the crew and their tools: pipe, fixtures, fuel, or a passenger who is not an employee. Say so if a vehicle tows.

Some carriers keep light and heavy vehicles together and some separate them; that is a placement question for your agent. The broader insurance picture for a company with service vans shows where the vehicle policy sits next to the rest of the account.

How are rented vans and employees’ own vehicles handled?

The National Association of Insurance Commissioners notes that commercial auto policies typically have provisions for rented vehicles and for employee-operated or employee-owned vehicles. In the industry, that part of the policy is usually called hired and non-owned auto. Whether it is present on your policy, and how far it goes, is a matter of the policy itself, so ask.

Two common situations: you rent a larger van for a big commercial job or while one of yours is in the shop, or a technician uses a personal pickup to carry a part or reach a job. The company did not buy either vehicle, yet it can still be drawn into an accident involving it.

Triple-I raises the second situation directly: a good agent will ask whether employees are likely to drive their own cars for the business. It is not an unusual question for a plumbing company, and the honest answer is often yes, at least occasionally. Tell your agent. Ask what the policy does when an employee is driving a personal vehicle for company errands, and how that interacts with the employee’s own personal auto policy.

If you would rather employees never use their own vehicles for work, say so to your crew in writing and hold to it.

Keep in mind that personal auto policies typically exclude vehicles used for business purposes, according to the National Association of Insurance Commissioners. That is a limitation worth understanding for the employee’s own policy, and it is the focus of the comparison of personal and commercial auto for plumbers.

Real-World Scenario: Picture a plumbing company that runs several service vans and a pickup the owner uses for estimates. A new technician is hired in the spring, and the owner mentions him to the agent only by first name in a phone call. In the summer, the company rents a larger van for a commercial job, and one of the crew uses a personal pickup to collect a part. At renewal the owner finds that the driver list never included the new hire, the rental was never discussed, and nobody asked how the personal pickup fit. The owner walks the agent through each vehicle and driver, and the policy is brought back into line.

What should you gather before asking for a multi-vehicle quote?

Gather a short list of facts before you call, and the conversation will move faster and be more accurate. The goal is to hand your agent the same information an underwriter will ask for, in the order they will ask it.

  • Every vehicle you own or lease for the business, with identifiers, titling and how each is used.
  • The people who drive, with license information, and who is assigned a vehicle versus who shares.
  • Anyone who drives occasionally, including office staff and apprentices.
  • Whether you rent vehicles, how often, and for what kinds of jobs.
  • Whether employees use their own vehicles for work, even now and then.
  • Any trailers, towing or heavier hauling, and any vehicle that carries more than tools.

When you are ready, you can request a plumbing insurance quote and send the vehicle and driver details above. The Triple-I article on whether a business needs a commercial auto policy is a useful independent read before the call, and the National Association of Insurance Commissioners keeps a topic page on auto insurance for general background. For the policy lines themselves, return to the commercial auto page and ask your agent to walk the schedule with you, vehicle by vehicle.

The bottom line

Several vans and trucks normally sit on one commercial auto policy, with every vehicle and driver listed, and with rented vans and employee-driven vehicles addressed on purpose. Keep the schedules current as the fleet changes.

Frequently asked questions

Can every plumbing van be on a single policy?

Usually, yes. A plumbing business with several vehicles normally insures them together on one commercial auto policy, with each vehicle listed on a schedule and each driver disclosed to the carrier. Whether a particular carrier writes all your vehicle types together depends on the fleet, so ask your agent to confirm before you assume it.

Do I list every employee who might drive a company van?

Plan on listing anyone who will regularly drive, and tell your agent about anyone who might drive occasionally, such as an apprentice or an office employee running a parts errand. Carriers differ on how they treat unlisted drivers, so ask how the policy handles someone who is not on the driver list before the situation arises.

What happens to the policy when I sell a van?

Tell your agent when the van is sold so the vehicle is removed from the schedule and the policy reflects what you actually own. Do not simply stop using it and assume the policy adjusts itself. Ask how the change takes effect and whether anything is owed or returned, since that is handled under the policy’s own terms.

Does the policy cover a rental van we use for a big job?

The National Association of Insurance Commissioners notes that commercial auto policies typically have provisions for rented vehicles. How far those provisions go depends on the wording of your policy. Ask your agent to explain how a short-term rental would respond before you rent, and read what the rental company offers separately.

What if a tech uses a personal pickup for a service call?

The National Association of Insurance Commissioners notes that commercial auto policies typically have provisions for employee-operated or employee-owned vehicles, often described as non-owned auto. That is separate from insuring the pickup itself. The employee’s own personal policy and the company policy can both come into play, so ask your agent how the two fit together.

Is a vehicle I lease handled differently from one I own?

It can be. A leased vehicle is typically still listed on the schedule, and the leasing company may attach its own requirements about how the vehicle is insured. Show your agent the lease terms before the policy is written so the schedule, the named parties and any lease requirements line up from the first day.

About the author

Nate Jones, CPCU

Nate Jones, CPCU, is the founder of Wexford Insurance and Plumbing Guard Insurance, a specialty insurance agency placing plumbing contractor coverage in 48 states across a 25-carrier specialty panel. He works with plumbing contractors on how vehicles, drivers and vehicle use are described to an underwriter, and on keeping the policy aligned as vans come and go. Connect via the Plumbing Guard Insurance quote form or call 317-942-0549.

Insure your plumbing operation with a CPCU-led agency

Tell us how you work — residential service and remodel, or commercial systems and new construction — and we will market it to carriers that write the plumbing class.